Mechanical Installation; Important Notes; Guide To Mechanical Installation - Danaher Motion 601...620 Product Manual

Danaher Motion

Mechanical Installation

7
7.1

Important notes

l
l
l
l
7.2

Guide to mechanical installation

The following notes should assist you to carry out the mechanical installation in a sensible
sequence, without overlooking anything important.
Ventilation
Grounding
®
SERVOSTAR 601...620 Product Manual
Protect the servo amplifier from impermissible stresses. In particular, do not let any
components become bent or any insulation distances altered during transport and handling.
Avoid contact with electronic components and contacts.
Ensure that there is an adequate flow of cool, filtered air into the bottom of the switchgear cabi-
net or use heat exchangers. Observe page 19 .
Take care that the servo amplifier and motor are earthed (grounded) properly. Do not use
painted (non-conductive) mounting plates.
Don't mount devices, which produce magnetic fields, directly beside the servo amplifier. Strong
magnetic fields could directly affect internal components. Install devices which produce mag-
netic field with distance to the servo amplifiers and/or shield the magnetic fields.
In a closed switchgear cabinet. Observe page 19 .
The site must be free from conductive or corrosive materials.
Site
For the mounting position in the cabinet ð p. 36
Check that the ventilation of the servo amplifier is unimpeded
and keep within the permitted ambient temperature ð p. 19 .
Keep the required space clear above and below the servo amplifier ð p 36.
Assemble the servo amplifier and power supply, filter and choke close
Assembly
together on the conductive, grounded mounting plate in the cabinet.
EMC-compliant (EMI) shielding and grounding (ð p. 47)
Earth (ground) the mounting plate, motor housing and CNC-GND of the controls.
Shielding
Notes on connection techniques are on page 42
07/2007
Mechanical Installation
35