Digital And Analog Inputs And Outputs; Analog Inputs (X3) - Danaher Motion 601...620 Product Manual

Danaher Motion
8.14

Digital and analog inputs and outputs

8.14.1

Analog inputs (X3)

The servo amplifier is equipped with two differential inputs for analog setpoints which are
programmable. AGND (X3/1) must always be joined to the CNC-GND of the controls as a ground
reference.
Technical characteristics
—
—
—
—
—
—
Input Analog-In 1 (terminals X3/4-5)
Differential input voltage max. ± 10 V, resolution 14-bit, scalable
Standard setting : speed setpoint
Input Analog-In 2 (terminals X3/6-7)
Differential input voltage max. ± 10 V, resolution 12-bit, scalable
Standard setting : torque setpoint
Application examples for setpoint input Analog-In 2:
—
—
—
Fixing the direction of rotation
Standard setting : clockwise rotation of the motor shaft (looking at the shaft end)
—
—
To reverse the direction of rotation, swap the connections to terminals X3/4-5 and. X3/6-7 or
change the ROT. DIRECTION parameter in the "Speed controller" screen.
®
SERVOSTAR 601...620 Product Manual
Differential-input voltage max. ± 10 V
Resolution 1.25 mV
Ground reference AGND, terminal X3/1
Input resistance 20 kW
Common-mode voltage range for both inputs ± 10 V
Update rate 62.5 µs
SERVOSTAR 600
adjustable external current limit
reduced-sensitivity input for setting-up/jog operation
pre-control / override
Positive voltage between terminal X3/4 (+ ) and terminal X3/5 ( - ) or
Positive voltage between terminal X3/6 (+ ) and terminal X3/7 ( - )
07/2007
Electrical Installation
65