Technical Description; The Servostar 600 Family Of Digital Servo Amplifiers - Danaher Motion 601...620 Product Manual

Technical description

Technical description
6
6.1

The SERVOSTAR 600 family of digital servo amplifiers

Standard version
l
l
l
l
l
l
l
l
Electrical supply
l
l
l
l
l
l
l
l
l
l
Integrated safety
l
l
l
16
6 current ratings (1.5 A -Europe only-, 3 A , 6 A , 10 A , 14 A, 20 A)
3 instrument widths : 70 mm for 1.5A up to 10A rated current
Wide range of rated voltage (3x208V
Shield connection directly at the servo amplifier
2 analog setpoint inputs
Integrated CANopen (default 500 kBaud), for integration into CAN bus systems and for
setting parameters for several amplifiers via the PC-interface of one amplifier
Integrated RS232, electrically isolated, integrated pulse-direction interface
Synchronous servomotors, linear motors and asynchronous motors can be used
Directly off grounded 3 phase system,
230V ... 480V
-10%
208V ... 480V
-10%
TN-system or TT-system with grounded neutral point, max. 5000 rms symmetrical amperes.
Connection to other mains supply networks only with insulating transformer ð p.48
B6 rectifier bridge, directly off 3-phase earthed (grounded) supply system, integral power input
filter and inrush circuit
Single-phase supply (e.g. for setup) is possible
Fusing: (e.g. fusible cutout) provided by the user
Shielding: All shielding connections directly on the amplifier
Output stage: IGBT- module with isolated current measurement
Regen circuit: with dynamic distribution of the regen power between several
amplifiers on the same DC bus link circuit. Internal regen resistor as
standard, external regen resistors if required
DC bus link voltage 260 — 900 VDC, can be switched in parallel
Interference suppression filter for the supply input (to category 3) is integrated
Interference suppression filter for the 24V aux. supply (to category 3) is integrated
Safe electrical separation to EN 50178 between the power input / motor connections and the
signal electronics, provided by appropriate insulation/creepage distances and complete electri-
cal isolation
Soft-start, overvoltage recognition, short-circuit protection, phase-failure monitoring
Temperature monitoring of servo amplifier and motor
(when using our motors with our pre-assembled cables)
07/2007
100 mm for 14A rated current
120 mm for 20A rated current
to 3x480V
–10%
+10%
, 50 Hz,
+10%
, 60 Hz
SERVOSTAR
Danaher Motion
+10%
)
®
601...620 Product Manual