Sine Encoder 5V With Biss (X1) - Danaher Motion 601...620 Product Manual

Danaher Motion
8.11.2

Sine Encoder 5V with BISS (X1)

Wiring of a single-turn or multi-turn sine-cosine encoder with BISS interface as a feedback system
(firmware revision from 6.68). During start-up of the servo amplifier the parameters stored in the
encoder eeprom are uploaded, after that phase only the sine/cosine signals are used.
The thermostat contact in the motor is connected via the encoder cable to X1 and evaluated there.
All signals are connected using our pre-assembled encoder connection cable.
Encoder types with a power consumption of more than 150mA can also be connected using our
external power supply (ð p. 113). For encoders that do not have integrated terminating resistors,
we offer an optional terminating adapter (ð p.
If cable lengths of more than 50m are planned, please consult our customer service.
Frequency limit (sin, cos): 250 kHz
FBTYPE 20
®
SERVOSTAR 601...620 Product Manual
07/2007
SERVOSTAR 600
Electrical Installation
113).
53