Introduction; Purpose Of These Operating Instructions; Document Version; Disclaimer - Danfoss VLT OneGearDrive Operating Instructions Manual

Introduction

1 1
1 Introduction

1.1 Purpose of these Operating Instructions

The purpose of these operating instructions is to describe
®
the VLT OneGearDrive. These operating instructions
contain information about:
•
Safety
•
Installation
•
Commissioning
•
Maintenance and repair
•
Specifications
•
Options and accessories
NOTICE
For reasons of clarity, the operating instructions and
safety information do not contain all information relating
to all OneGearDrive types and cannot take into account
every conceivable case of installation, operation, or
maintenance. The information is limited to that which is
required for qualified personnel in normal working
situations. Contact Danfoss for further assistance.
These operating instructions are intended for use by
qualified personnel. Read these operating instructions in
full in order to use the OneGearDrive safely and profes-
sionally. Pay particular attention to the safety instructions
and general warnings.
These operating instructions are an integral part of the
OneGearDrive and also contain important service
information. Keep these operating instructions available
with the OneGearDrive at all times.
Compliance with the information in these operating
instructions is a prerequisite for:
•
Trouble-free operation.
•
Recognition of product liability claims.
Therefore, read these operating instructions before
working on or with the OneGearDrive.
®
VLT is a registered trademark.
4
Operating Instructions

1.2 Document Version

This document is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version.
Table 1.1 Document Version

1.3 Disclaimer

No liability is assumed for any damage or breakdown
resulting from:
•
•
•
•

1.4 Product Overview

1.4.1 Intended Use

The OneGearDrive is intended for commercial installations,
unless otherwise expressly agreed. It complies with the
standards of the series EN 60034/DIN VDE 0530. Use in a
potentially explosive atmosphere is forbidden, if not
expressly intended for this purpose. Increased safety
precautions (for example protection against access by
children's fingers) are required in special cases, such as use
in non-commercial installations. Ensure these safety
conditions when setting up the installation. The
OneGearDrive is designed for ambient temperatures
between -20 ˚C to 40 ˚C as well as for installation heights
up to 1000 m above sea level. Any deviations found on
the nameplate must be considered. Ensure that the
conditions at the place of work correspond to all the
nameplate data.
Low-voltage machines are components for installation in
machines in the sense of the machinery directive
2006/42/EC.
•
Danfoss A/S © 06/2014 All rights reserved.
Edition
MG75C4xx Replaces MG75C3xx
Failure to observe the information in the
instruction manuals.
Unauthorised modifications to the OneGearDrive.
Operator error.
Improper work on or with the OneGearDrive.
CAUTION
Do not use the machine until conformity of the
final product with this directive is established
(refer to EN 60204-01).
Remarks
MG75C402