Cage Clamp Connection Diagram - Danfoss VLT OneGearDrive Operating Instructions Manual

Electrical Installation

4.4 Cage Clamp Connection Diagram

Illustration 4.3 shows the OneGearDrive DA09LA10 with terminal box in Y-connection and the connection to the thermal
protection.
4 4
Illustration 4.3 Cage Clamp Connection Diagram
Description
Motor winding
Protective earth
Temperature protection
KTY 84-130
Table 4.1 Cage Clamp Connections
1) When connected to VLT
information about parameter setting and programming, refer to the corresponding operating instructions.
T1
T2
Table 4.2 Connections T1 and T2
1) Only if connected
NOTICE
After connection, tighten all 4 screws on the terminal box cover. The tightening torque is 3 Nm.
14
V1
Inverter output
U
V
W
PE
1) T1
T2
®
AutomationDrive FC 302 and VLT
®
VLT AutomationDrive FC 302
KTY 84-130
Danfoss A/S © 06/2014 All rights reserved.
Operating Instructions
W1
U1
U V W PE
U V W
Colour Typical cross-section
Black
1.5 mm
Blue
Brown
Yellow/green
1.5 mm
White
0.75 mm
Brown
®
Decentral Drive FCD 302, use analog input terminal 54, KTY sensor 1. For
1)
KTY sensor 1
Analog input 54
T1 T2
Maximum cross-section
2 2
/AWG 16 2.5 mm /AWG 14
2 2
/AWG 16 2.5 mm /AWG 14
2 2
/AWG 20 1.5 mm /AWG 16
®
VLT Decentral Drive FCD 302
1)
MG75C402