Signal Setting - Vidicode 1390 Manual

Speech detection
In this case the recorder reacts to a signal on the line. Speech detection
should be used in combination with "Signal Setting", which is discussed
below. Speech detection is not advisable when one is recording from the line,
as the recorder might be set off by not just speech, but by any other signal on
the line, such as a ring from the phone.
Opening contact or Closing Contact
These settings are used when the "Switch" port of the recorder is connected
to an external contact such as can be found in various telephone exchanges
and apparatuses. Recording starts whenever the external contact opens or
closes.
Manually
Of course it is also possible to start recordings manually. When manual
recording has been selected, recording is started by pressing the Record
button and stopped by pressing the Stop button. Note: This setting is an
exception because the normal function of the Record button is not to start a
microphone recording, but to answer the question from which source one is
recording: line, handset or microphone.
3.1.3

Signal Setting

This question concerns the level of the signal above which the recorder will
automatically start to record. Only when speech detection has been selected
in the preceding question will the following question be shown on the display:
Signal Setting
NEXT CHANGE
To set this select 'CHANGE' and the signal level measure will appear on the
display:
A4•••:•|••••••••••••••••
<< >>
Call Recorder Manual ©-2001 Vidicode Datacommunicatie BV
STOP
BACK
25