Module Insertion; Data Receiver Modules; Ltc 8916/01 Data Receiver Modules - Bosch LTC 8900 Series Installation Manual

LTC 8900 Series
5.5

Module Insertion

A special tool is supplied with the system components, for insertion of the Data Receiver,
Video Input Module, and Video Output Module boards into LTC 8902 and LTC 8903 Series
equipment bays. The tool is a simple lever (an angled piece of aluminum), used as
follows:Insert the board fully into the slot, ensuring proper alignment with the
connectors.Insert the short end of the lever into the groove in the front of the bay so the tool
is aligned with the card ejectors on the card, then push the lever to force the card into the
slot.
Figure 5.4: Example of Insertion Tool Use
5.6

Data Receiver Modules

LTC 8902 Series Video Output bays are supplied with LTC 8916/01 Data Receiver
modules.LTC 8903 Series Video Input bays are supplied with LTC 8918/01 Data Receiver
modules.Data Receiver Modules are installed into the right most slot (adjacent to the power
supply) of the matrix bays as shown below:
Figure 5.5: Typical Data Receiver Module Insertion
5.7

LTC 8916/01 Data Receiver Modules

The LTC 8916/01 Data Receiver modules (installed in LTC 8902 Series bays) contain three (3)
8-position dip switches.
For system configurations of up to 2048 cameras and 512 monitors, , page 66 can be used as
a guide for setting the Data Receiver DIP switches. Otherwise, follow the procedure described
below.
Bosch Security Systems, Inc.
Hardware Installation Procedure for Standard Systems Utilizing LTC 8904 Series CPU |
IN S R -T O L
Installation Manual
23
en
2015.01 | 10.6 |