Copyright Statement; Important Notices - SPX Radiodetection RD8000 User Manual

Copyright statement

Copyright 2013 Radiodetection Ltd. All rights reserved. Radiodetection is a subsidiary
of SPX Corporation. SPX, the green ">" and "X" are trademarks of SPX Corporation,
Inc. Radiodetection is a trademark of Radiodetection Ltd. Due to a policy of continued
development, we reserve the right to alter or amend any published specification without
notice.
This document is protected by copyright and may not be copied, reproduced,
transmitted, modified or used, in whole or in part, without the prior written consent of
Radiodetection Ltd.
Trademarks
RD8000, RD7000, RD4000, SurveyCERT, eCAL, StrikeAlert, SideStep and iLOC are
trademarks of Radiodetection Ltd.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use
of such marks by Radiodetection is under licence.

Important notices

When reporting any problems to your Radiodetection Dealer or Supplier it is important to
quote the unit serial number and the purchase date.
WARNING! This equipment is NOT approved for use in areas where hazardous
gases may be present.
WARNING! When using the transmitter, switch off the unit and disconnect
cables before removing the battery pack.
Reduce audio level before using the earpiece.
Batteries should be disposed of in accordance with your company's work practice, and/
or any relevant laws or guidelines in your country.
This instrument, or family of instruments, will not be permanently damaged by
reasonable electrostatic discharge and has been tested in accordance with IEC 801-2.
However, in extreme cases temporary malfunction may occur. If this happens, switch off,
wait and switch on again. If the instrument still malfunctions, disconnect the batteries for
five seconds and then reinstall and switch the unit on.
WARNING! The RD8000 will detect almost all buried conductors but there are
some objects that do not radiate any detectable signal. The RD8000, or any other
electromagnetic locator, cannot detect these objects so proceed with caution.
There are also some live cables which the RD8000 will not be able to detect in
Power mode. The RD8000 does not indicate whether a signal is from a single
cable or from several in close proximity.
23