Table of Contents
Advertisement
Available languages
Available languages
Before you begin
IMPORTANT! Please read this section before you attempt to operate the RD8000!
System setup
It is important that you set up the system according to your personal preferences and
operating requirements before you conduct your first survey. You can set the system up
using the RD8000 menu as described below.
Before changing settings, ensure the locator or transmitter is switched on by pressing
the
key for two seconds.
Using the menu
The RD8000 locator and transmitter menus allow you to select or change system
options. Once entered, the menu is navigated using the arrow keys. Navigation is
consistent on both the transmitter and the locator. When in the menu, most on-screen
icons will temporarily disappear and the menu options will appear in the bottom left-hand
corner of the LCD. Note that when browsing the locator menu, the
as left and right arrows. When browsing the transmitter menu the
left and right arrows. The right arrow enters a submenu and the left arrow returns to the
previous menu.
NOTE: When you select an option and press the Left arrow, the option will be
enabled automatically.
Locator menu options
•
VOL: Adjust the speaker volume from 0 (mute) to 3 (loudest).
•
LOG: Delete, send or review saved SurveyCERT measurements.
•
BT: Enable, disable, reset or pair Bluetooth
•
UNIT: Select metric or imperial units.
•
CAL: Displays the date of original factory calibration and the most recent eCAL
•
LANG: Select your preferred system language.
•
POWER: Select national power frequency: 50 or 60Hz.
•
ANT: Enable of disable any antenna mode with the exception of Peak.
•
FREQ: Enable or disable individual frequencies.
•
ALERT: Enable or disables StrikeAlert
•
BATT: Sets battery type. NiMH or ALK.
•
COMP: Enable or disable display of the Compass feature.
connections.
®
.
™
10
and
keys act
and
keys act as
Advertisement
Table of Contents
