SPX Radiodetection RD8000 User Manual page 15

Changing transmitter power output
1. Pair the locator and the transmitter if you have not already done so.
2. Transmitter power options are located in the TXOUT menu on the locator. Press and
hold the key until the TXOUT menu is displayed.
3. Press the key to enter the TXOUT menu.
4. Scroll through the power output options using the
are:
• STDBY, LOW, MED, HIGH, MAX and BOOST.
• Once you have selected the mode you want, press the
5. Next press and hold the
6. Press the key once to send the settings to the transmitter.
Using SideStep
SideStep allows you to adjust the frequency by a few Hz to avoid interference where
present.
1. Pair the locator and the transmitter if you have not already done so.
2. On the locator, press and hold the
3. Press the key on the locator to send the SideStep command to the transmitter.
4. If the command is sent successfully, an asterisk (*) will appear next to the frequency.
Sleep/Wake the transmitter
You can set the transmitter to sleep and wake it when required to help you prolong
battery life.
To put the transmitter to sleep, set it to STDBY using the procedure described above.
To wake the transmitter, select any power mode from LOW to BOOST using
the procedure described above.
NOTE: If any iLOC commands fail, you may be too far from the transmitter
or your line of sight maybe obstructed by buildings or large vehicles.
Move closer to the transmitter and repeat the process.
key to select the new setting and exit the menu.
key until STEP appears on the display.
15
or keys; available options
key to confirm.