Leuze electronic MA 258i Operating Instructions Manual page 72

Commissioning and configuration
Figure 12.3: Making network settings
 Select the connected device via the device selection switch.
 Apply the supply voltage +18 ... 30VDC (typ. +24VDC); the MA
 Now switch the service switch to "MA".
 Now start a web browser by entering the IP address into the navigation bar. You will be
shown a page for the direct setting of the addresses.
Notice!
The service switch must be in switch position "MA" for the MA 208i to start in configuration
mode.
 Connect the serial RS 232 Sub-D interface of the MA
computer.
 Make the respective settings on the configuration page opened in the web browser.
70 MA 258i
258i starts up.
258i to the serial interface of your
Leuze electronic