Fast Commissioning / Operating Principle; Mounting; Device Arrangement And Selection Of The Mounting Location; Electrical Connection - Leuze electronic MA 258i Operating Instructions Manual

Fast commissioning / operating principle

3 Fast commissioning / operating principle
Notice!
Below you will find a short description for the initial commissioning of the EtherNet/IP
gateway MA 258i. Detailed explanations for the listed points can be found throughout the
handbook.
3.1

Mounting

The gateway mounting plate MA
• using four threaded holes (M6) or
• using two M8x6 screws on the two lateral grooves.
3.2

Device arrangement and selection of the mounting location

Ideally, the MA
in order to ensure good operability, e.g., for configuring the connected device.
Detailed information can be found in chapter 6.3.1.
3.3

Electrical connection

The devices from the MA
differently depending on the interface.
The voltage supply (PWR IN) as well as the switching inputs/outputs (PWR OUT or PWR IN)
are connected there. The number and function of the switching inputs/outputs is dependent
on the connected end device.
An internal RS 232 interface is used for connecting the respective Leuze device. Another
internal RS 232 interface functions as a service interface for configuring the connected
device via a serial null modem cable.
PWR IN
SWIO_2
2
GND
3
5
4
FE
SWIO_1
M12 connector
(A-coded)
Figure 3.1:
Detailed information can be found in chapter 7.
10
258i should be mounted so that it is easily accessible near the Ident device
2xxi family feature four M12 connectors/sockets which are coded
PWR OUT
SWIO_2
2
VIN VOUT 1
1
5
4
SWIO_1
M12 socket
(A-coded)
MA 258 connections
258i can be mounted in two different ways:
LEUZE Device
GND
3
FE
MA 258i
HOST / BUS IN
RD+
2
TD+ 1 TD-
3
4
RD-
M12 socket
(D-coded)
Leuze electronic
BUS OUT
RD+
2
TD+ 1 TD-
3
4
RD-
M12 socket
(D-coded)