Leuze electronic MA 258i Operating Instructions Manual page 52

Configuration
Figure 9.1:
Notice!
Observe that STX, data, CR, LF framing must be set on the PC terminal program so that
communication is possible with the connected Leuze device.
Commands
You can now call up information on the MA
v
s
l
Table 9.1:
Information
Version
Firmware date
Table 9.2:
50
COM port settings
General service information.
Enable memory mode for the last frames.
The memory mode shows the last RX and TX frames for ASCII and fieldbus.
Available commands
General firmware information
258i by sending the following commands.
Version information.
Firmware date.
MA 258i Leuze electronic