Resetting The Parameters (S4 Switch Position F) - Leuze electronic MA 258i Operating Instructions Manual

16.13 Resetting the parameters (S4 switch position F)

To reset all parameters of the MA that can be configured with software (such as baud rate,
IP address, dependent on type) to the factory settings, do the following:
 Set device switch S4 to F in a voltage free state.
 Switch the voltage on and wait until it is ready for operation.
 If necessary, switch the voltage off to prepare for commissioning.
 Set service switch S10 to the "RUN" position.
Leuze electronic
Specifications for Leuze end devices
MA 258i 111