Configure The Config Assembly - Leuze electronic MA 258i Operating Instructions Manual

Attention!
If the configuration assembly is addressed with instance 118 and length 12 in the input mask
for the generic module, all MA
moment. All default parameters of the MA must be manually entered in the configuration
assembly. Changing the individual default values is possible at any time.
For the exact description of the assemblies for input/output and configuration, please refer
to chapter 12.6.2.
The query cycle of the input and output assemblies is subsequently defined in the Module
properties -> Connection path in the Request packet interval (RPI) input field.
The participant is thereby defined in offline mode; the data must subsequently be transferred
to the control.

12.3.2 Configure the config assembly

The MA 258i
of the MA 258i
The config assembly must include all parameters that affect the MA 258i. The config
assembly is automatically written to the connected participants in cycles that the control
manufacturer defines.
The config assembly is implemented in class 4, under instance 118. By default, all param-
eters are preset to the value 0 (zero).
Attention!
If the config assembly is not adapted, the MA
to the parameters preset with 0.
 Switch the control to offline mode.
 Double-click
The configuration assembly can be recognized by the index "C" appended to the device
name.
Parameter entry is performed as described in section "Setting MA parameters manually via
the config assembly" on page 74.
Leuze electronic
258i
makes available a configuration assembly that allows the entire parameter set
to be saved in the control and, if necessary, to be called up.
Controller tags
Commissioning and configuration
parameters with the value 0 are occupied in the first
258i displays a corresponding behavior acc.
to edit the configuration assembly.
MA 258i 73