Leuze electronic MA 258i Operating Instructions Manual page 100

Specifications for Leuze end devices
KONTURflex specifications
Settings on the MA
• EtherNet address is freely selectable
• Device selection switch at position "0"
EtherNet settings
• Produced/Consumed data settings:
Dependent on number of beams used, but at least "20 bytes In/4 bytes Out"
• User parameters:
"Transparent mode", "Use ESD settings", baud rate 38400, "4 data bits",
"No parity", "2 stop bits"
KONTURflex settings
First, the following settings are to be performed on the device using KONTURFlex-Soft:
• Either "Autosend (fast)" or "Autosend with data in Modbus format"
• Repeat time "31.5ms"
• Autosend baud rate "38.4KB"
• 2 stop bits, no parity
98
258i
MA 258i Leuze electronic