3.4
Faults, faults and remedy
Error
WC does not flush
WC flush runs through
manual actuation is not working
WC flush actuation
Remove the cable of the programming contact.
Place a protective cap onto the contact.
Cause
Power supply failure
Cistern is not yet completely full
No water in cistern, corner valve is
closed
Control defect
Plug connection power pack /
control not made
Plug connection drive unit / control
not made
Dirty seal in filling valve
Dirty seal in drain valve
Plug sequence drive unit / control
incorrect
The mechanism is not connected
to the bow
Remedy
actuate manual flush
Wait until the cistern is sufficiently
full
Open corner valve
Replace control
Create plug connection
Ä „Con‐
necting the control" on page 26
Create plug connection
Ä „Con‐
necting the control" on page 26
Check seal, replace if necessary
Check seal, replace if necessary
Check plug connection, observe
coloured marking
Ä „Connecting
the control" on page 26
Hang the mechanism in the bow
Handling
46 from 48