External sensors (optional)
3.1.2
Required material and tools
Material
Tool
WC flush actuation
Fig. 11: Protected zones
According to the applicable regulations, installation of the power pack in
the protected zones 0 and 1 of shower rooms and bathrooms is not per‐
mitted, see
Ä „Regulations from section: Fields of application /
Mounting conditions" on page 6.
We recommend installing the power pack outside of the protected
zones 0–2.
If external sensors are to be connected to the control, their connection
lines or protective pipes must be laid in the cistern before tiling is
begun.
The following material is required for mounting:
a suitable flush plate
Ä „Suitable manual flush plates" on page 7
n
Programming set
Ä „Optional accessories" on page 15
n
if necessary, empty pipe from power pack into the cistern
n
if necessary, accessories for the extension of the system
n
2.4.4 „System expansions" on page 11
The following tools are required for mounting:
flat screwdriver
n
spanner (SW 19)
n
knife (cutter)
n
Handling
Ä Chapter
18 from 48