Engine Start - Rotax 912 iS Sport Operator's Manual

3.3) Engine start

Engine start
Page 3-6
January 01 2019
Step Procedure
3 This process is finished when air is returning back to the
oil tank and can be noticed by a gurgle from the open oil
tank.
4 Check oil level and add oil if necessary.
The oil level should be in the upper half (between the
"50%" and the "max" mark) and should not fall below the
"min." mark of the oil dipstick. Prior to long flights oil
should be added so that the oil level reaches the "max"
mark.
Avoid oil levels exceeding the "max" mark, since excess
oil could be poured out through the venting system.
Difference between max.- and min.- mark = 0.45 litre
(0.95 liq pt). Oil consumption max 0.06 l/h (0.13 liq pt/h).
5 Re-install bayonet cap.
ENVIRONMENTAL NOTE
Protect the environment.
Do not harm the environment by spilling oil. Dispose of oil in an envi-
ronmentally friendly manner.
Non-compliance can result in serious injuries or death!
Do not start the engine if any person is near the engine.
Step Designation
1 Fuel valve.
2 Accomplish aircraft spe-
cific startup.
3 Master Switch.
4 Fuel pump
BRP-Rotax
m WARNING
Procedure
open
activate Flight Display
ON
ON
Effectivity: 912 i Series
Edition 2 / Rev. 0