Rotax 912 iS Sport Operator's Manual page 40

Page 3-8
January 01 2019
Activate starter for maximum of 10 seconds only (without inter-
ruption), followed by a cooling period of 2 minutes.
Step Designation
11 Throttle valve.
12 Engine instruments.
Increasing engine speed is only permitted at steady oil pressure
readings above 3 bar (43.5 psi).
Step Designation
13 Throttle valve.
If, after the engine start, a warning lamp flashes or lights up, perform
a Lane and IGNITION check. After the Lane and IGNITION check
both warning lamps must be deactivated, otherwise there is an error.
If one of the lamps illuminates or flashes: abnormal operation.
Step Designation
14 Engine instruments.
BRP-Rotax
ATTENTION
Procedure
Reduce throttle valve po-
sition as required.
Check status of warning
lamps and ensure compli-
ance with the operating
limits using the engine in-
struments. Check if oil
pressure has risen within
10 seconds after engine
start and monitor oil
pressure..
ATTENTION
Procedure
Increase engine speed
above 2500 rpm and hold
for 5 seconds (Generator
B shifts to Generator A).
ATTENTION
Procedure
Check status of warning
lamps and ensure compli-
ance with the operating
limits using the engine
instruments.
Effectivity: 912 i Series
Edition 2 / Rev. 0