Table of Contents
Advertisement
no.
shape nos. 10, 11, 12: Belt loop clamping position shifting
function
For shape Nos. 10, 11 and 12, ths swtch s used to select the
functon that shfts the belt loop clampng poston by movng the
clamp wth the belt loop pressed by the work clamp foot after the
2nd sewng.
shape nos. 10, 11, 12: 3rd sewing position
correction in terms of longitudinal direction of
clamp
For shape Nos. 10, 11 and 12, the 3rd sewng poston
of the clamp can be corrected n longtudnal drecton.
shape nos. 10, 11, 12: Garment-body feed 3rd
sewing position correction
For shape Nos. 10, 11 and 12, the 3rd sewng poston
of the garment body feed can be corrected.
caution: If this sewing data is changed, dimension
shape nos. 10, 11, 12: Belt loop clamping position
correction in terms of longitudinal direction of
clamp
For shape Nos. 10, 11 and 12, the clamp poston at the
tme when the belt loop s pressed by the work clamp
foot can be corrected n longtudnal drecton, whle the
belt-loop clampng poston shftng functon s enabled.
shape nos. 10, 11, 12: Garment-body feed belt-loop
clamping position correction
For shape Nos. 10, 11 and 12, the garment body feed
poston at the tme when the belt loop s pressed by the
work clamp foot can be corrected whle the belt-loop
graspng poston shftng functon s enabled.
shape nos. 10, 11, 12: Belt-loop clamping position
shifting amount correction in terms of longitudinal
direction of clamp
For shape Nos. 10, 11 and 12, the belt-loop clampng
poston shftng amount by movng the clamp to the
far sde after the work clamp foot presses the belt-loop
can be corrected, whle the belt-loop graspng poston
shftng functon s enabled.
* : Data marked with an asterisk (*) are not displayed on the sewing data list screen. they are displayed,
however, from the data entry screen.
: Data in a gray box are not displayed in the standard state. to display them, refer to the Engineer's Manual.
Item
: Automatc
Enable/dsable of the belt loop clampng poston shftng
operaton s automatcally changed over accordng to
the set value of the belt loop dmenson.
: Enable
The belt-loop clampng poston shftng operaton s
carred out at all tmes.
: Dsable
The belt-loop clampng poston shftng operaton s not
carred out.
B and dimension D will change.
– 89 –
Input range/
Initial
selection range
value
―
Automatc
-20.0 to 20.0
0
(mm)
(mm)
-3.0 to 3.0
0
(mm)
(mm)
-15.0 to 15.0
0
(mm)
(mm)
-15.0 to 15.0
0
(mm)
(mm)
-10.0 to 20.0
0
(mm)
(mm)
Advertisement
Table of Contents
