JUKI AB-1351 Instruction Manual page 121

Error
Display
code
Grease run-out warning
E220
Every tme the number of sttches
sewn has reached 100 mllon.
→ Refer to
the designated places with
grease", p.138.
Grease run-out error
E221
Every tme the number of sttches
sewn has reached 120 mllon, the
sewng machne s placed n "sewng
dsabled" state.
Ths error can be cleared wth
memory swtch
→ Refer to
the designated places with
grease", p.138.
Belt loop grease up alarm
E290
When the belt loop sewng has been
performed for one mllon tmes.
→ Refer to
the designated places with
grease", p.138.
Belt loop grease up error
E291
When the belt loop sewng has been
performed for 1.2 mllon tmes, the
machne wll no longer be able to
contnue sewng.
Ths stuaton can be reset by the
memory swtch
→ Refer to
the designated places with
grease", p.138.
E302 Machine head tilt check
When the machne head tlt sensor
s n the OFF state.
Meniscus sensor error
E303
E305 thread trimming knife sensor
error
The thread trmmng knfe s out of
ts normal poston.
thread grasping sensor error
E306
The thread clampng devce s out of
ts normal poston.
E363 sub-PWB error is detected
(Power is turned oFF)
sub-PWB error is detected
E364
(reset)
Description of error
"#-1-16. replenishing
.
"#-1-16. replenishing
"#-1-16. replenishing
.
"#-1-16. replenishing
– 116 –
Display message
How to Place of
recover recovery
Re-start Data
after nput
resettng s screen
enabled.
Re-start Data
after nput
resettng s screen
enabled.
Re-start Data
after nput
resettng s screen
enabled.
Re-start Data
after nput
resettng s screen
enabled.
Re-start Data
after nput
resettng s screen
enabled.
Turn OFF
the power
Turn OFF
the power
Turn OFF
the power
Turn OFF
the power
Turn OFF
the power