JUKI AB-1351 Instruction Manual page 122

Error
Display
code
Belt-loop draw-out auxiliary
E368
device position sensor fault
The poston sensor s not n ts
ntal poston on completon of the
operaton.
Belt-loop draw-out auxiliary
E369
device lock-up is detected
In the case the lock-up sensor stays
ON for a predetermned tme or
the poston sensor nput remans
unchanged at the tme of drvng.
→ In the case of a thck belt-loop,
the lock-up sensor may detect lock-
up state at the mult-layered part,
resultng n ths error. If ths error
occurs, change the lock-up detectng
condton settng approprately.
Belt-loop grasping failure
E377
Belt-loop drawing failure
E378
E379 Multi-layered part ejection
amount fault
When a mult-layered part of a belt-
loop s ejected, the ejecton amount
s faulty (the end of the mult-layered
part cannot be detected)
→ If ths error occurs at any part
other than the mult-layered part
of a belt-loop, check whether the
teachng value of the mult-layered
part thckness s approprate.
no belt-loop state is detected
E380
No belt-loop nserton state s
detected.
→ If ths error occurs when a belt-
loop has already been nserted
correctly, check whether the
teachng value of the mult-layered
part thckness s approprate.
clamp upper-position sensor
E386
fault (upper position)
The upper poston sensor s n the
OFF state or the lower poston
sensor s n the ON state when the
clamp rests at ts upper poston.
Description of error
– 117 –
Display message
How to Place of
recover recovery
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.
Re-start Data
after nput
resettng screen
s
enabled.