Table of Contents
Advertisement
2-4. Garment body presser/work clamp foot specifications
(1) Garment body presser
2
5
6
A
1. For belt loop shapes nos. 5 and 7, auxiliary clamps 4 and 6 are damaged since they
are rubbed by the fork pin which rolls the belt loop. If the auxiliary clamps are heav-
ily damaged, they can deform or break. It is necessary to periodically change auxiliary
clamps with new ones.
2. Install the auxiliary clamps at right angles to garment body pressers 1 and 2 . Be sure
to check that the auxiliary clamps do not interfere with other parts.
1
3
4
7
B
Garment body presser 1 and 2 for securng the
garment body s provded as standard wth auxl-
ary clamps 3 , 4 , 5 and 6 .
Be aware that the auxlary clamps 3 may be
requred to be removed accordng to the sewng
shape of the belt-loop.
In the case of two knds of sewng shapes; No. 2
and No. 6, auxlary clamp 3 has to be removed.
Loosen two screws 7 and remove the auxlary
clamps 3 from the garment body presser 1 .
If you have changed the garment body presser,
set the machne settng N802 accordng to the
garment body presser actually beng used.
A Addtonal clamp s provded
B Addtonal clamp s not provded
→ Refer to
"@-2-29. How to set the device"
– 6 –
,
p.98.
Advertisement
Table of Contents
