Table of Contents
Advertisement
3)
compactFlash (tM)
■ Inserting the compactFlash (tM)
1. When the inserting direction of the media is wrong, panel or media may be damaged.
2. Do not insert any item other than the compactFlash (tM).
3. the media slot in the IP-420 accommodates to the compactFlash (tM) of 2GB or less.
4. the media slot in the IP-420 supports the FAt16 which is the format of the compact-
Flash (tM). FAt32 is not supported.
5. Be sure to use the compactFlash (tM) which is formatted with IP-420. For the format-
ting procedure of the compactFlash (tM), see
media",
p.106.
■ removing the compactFlash (tM)
1)
2)
Media
1)
1
2)
2
– 28 –
Turn the label sde of the CompactFlash (TM)
to ths sde (place the notch of the edge to the
rear.) and nsert the meda that has a small
hole to the rear.
After completon of settng of the meda, close
the cover. By closng the cover, t s possble
to access. If the meda and the cover come n
contact wth each other and the cover s not
closed, check the followng matters.
•
Check that the meda s securely pressed
untl t goes no further.
•
Check that the nsertng drecton of the
meda s proper.
"@-2-32. Performing formatting of the
Hold the panel by hand, open the cover, and
press the meda removng lever 1 . The me-
da 2 s eject.
When the lever 1 is strongly pressed,
the media 2 may be broken by pro-
truding and falling.
When the meda 2 s drawn out as t s, re-
movng s completed.
Advertisement
Table of Contents
