Table of Contents
Advertisement
M
In the case a multi-layered part of
the belt loop is detected
M
In the case the absence of a belt
loop is detected
5 Display on the panel concerning the belt-loop multi-lay-
ered part detection/no belt-loop detection
When a belt loop s drawn out wth ths functon enabled after
L
confirmation of the data, the belt-loop status will be displayed
n secton M on the panel f the functon determnes the pres-
ence of a mult-layered part on the belt loop or the absence of
a belt loop.
To reset the dsplay and return to the normal dsplay (.e. noth-
ng s dsplayed), remove the mult-layered part f there was
a mult-layered part, or replensh the belt loop f there was no
belt loop, and press the clear button L on the nput screen.
L
– 54 –
Advertisement
Table of Contents
