Avaya S8300 Series Replacement Manual page 52

Job aids for field replacements (frus) with the g700 media gateway
Hide thumbs Also See for S8300 Series:
Table of Contents

Advertisement

Job Aid: Replacing the G700 Media Gateway
!
CAUTION:
If you need to change the mgc list, you must run clear mgc list before
CAUTION:
running set mgc list again.
The following table describes the possible optional controllers for an S8300, S8500,
S8700, and S8710 primary controller:
Primary
Server
S8300
S8500, S8700,
or S8710
16. (Only if the original G700 Media Gateway was NOT functional) Set the LSP transition
points.
You must set the time that the G700 searches, in the event of a network problem, for
primary controllers (for example, additional CLAN connections) with which to register. After
this search time has elapsed, the G700 will search for an LSP with which to register. You
must also set the total time the G700 searches for either a primary controller and an LSP,
after which the G700 resets. And finally, you must define how many primary controllers,
from 1 to 4, are in the controller list you just defined.
a. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search
<search-time>
where <search-time> is the time in minutes that the G700 searches for a primary
controller before looking for an LSP. The range is from 1 to 60.
b. At the MG-001-1(configure)# prompt, type set mgp reset-times total-search
<search-time>
where <search-time> is the time in minutes that the G700 searches for both primary
controllers or LSPs. The range is from 1 to 60.
c. At the MG-001-1(configure)# prompt, type set mgp reset-times
transition-point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the
primary controller is an S8500 or S8700, the range is from 1 to 4. If the primary controller
is an S8300, <#_of_primary> must be 1.
17. Reconnect to the primary server.
48 Job Aids for Field Replacements (FRUs) for the Avaya S8300 Media Server with the G700 Media
Controller IP Addresses
First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s configured
as LSPs.
First: IP address of the C-LAN for the S8500, S8700, or S8710
primary controller.
Next three: one, two, or three IP addresses of alternate C-LANs
and/or LSPs.

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300cS8300dS8300aS8300b

Table of Contents