Back Up Data - Avaya S8300 Series Replacement Manual

Job Aid: S8300 Communication Manager and co-resident SES: Replacing the S8300C or S8300D Server or
d. If you can see both "...sda" or "...hda" entries, the hard drive and onboard CompactFlash
are functional. Continue with
e. If you cannot see the "...sda" or "...hda" entries, power-cycle S8300C or S8300D (press
the Shutdown button on the S8300C or S8300D faceplate and hold the button until the
green "OK to Remove" LED starts blinking, wait for the LED to go steady on, then reseat
the S8300 server to initialize it again) and then repeat Steps a-c above. If you still cannot
see the "...sda" or "...hda" entries, the hardware is not functional, and you must use the
customer's backups (translations, SES database, operating system, security, and
messaging data and announcements) when you get to
Skip to

Back up data

To back up the data on the S8300C or S8300D Server:
1. On the Server (Maintenance) Web page select Data Backup / Restore > Backup Now.
The system displays the system displays Backup Now screen.
2. In the Data Sets section select (check) all of the following data sets:
- If the S8300C or S8300D Server is not an LSP, select ACP Translations; select Save
ACP translations before backup.
- Server and System Files.
- Security Files.
- SES Files.
- If Communication Manager Messaging is installed on the S8300C or S8300D Server,
select Communication Manager Messaging, also select Names, Translations and
Messages.
3. Select the Backup Method:
- Local PC Card (the USB-connected CompactFlash on the S8300C or S8300D Server)
Tip:
Backing up to the USB CompactFlash saves time during the
Tip:
page 32.
- Network Device: enter the customer-supplied information for:
Choose from FTP, SCP, or SFTP
●
User Name
●
Password
●
22 Job Aids for Field Replacements (FRUs) for the Avaya S8300 Server with the G700 Media Gateway
Power down the S8300C or S8300D
Back up data on page 22.
on page 23.
Restore Data on page 32.
Restore Data on