Avaya S8300 Series Replacement Manual page 21

d. Reboot the server.
13. Install any software service packs required.
14. Configure the S8300 and restore data. Do either Step
a. If the original hardware is functional or if the software release installed on the original
hardware is the same as or later than the release installed on the new hardware, then:
Configure the network data (Host Name, IP address, subnet mask, default gateway IP
●
address).
Restore all data.
●
b. If the original hardware is not functional and the software release installed on the original
hardware is either unknown or earlier than the release installed on the new hardware,
then:
Configure the S8300 as you would a new install using either the Avaya Installation
●
Wizard and the Pre-Installation Worksheet previously created, or using the Server
(Maintenance) Web page.
Restore only the translations and the Communication Manager Messaging
●
announcements
15. If the new hardware has a later software release than the original hardware, check to see if
you need to upgrade the media gateway firmware as described in Step
the customer site
16. Check for and resolve any new alarms.
17. Test as appropriate — for example, make station and trunk calls.
18. Save translations. If the S8300 on which you replaced the hardware is configured as an
LSP, save translations on the primary controller, not the LSP.
19. S8300B Only: Enable RAM disk on the server:
a. Access the server's command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6.
b. At the command line type sudo ramdisk -v -f enabled and press Enter.
The system does not display any information to the screen if there are no errors.
c. At the command line type ramdisk -v -s and press Enter.
Confirm that the setting in the ecs.conf file is the desired state after the next reboot.
!
Important:
DO NOT OMIT THE NEXT STEP.
Important:
20. S8300B and S8300C or S8300D: Reboot the server.
21. Install the license and authentication files.
a. Install the license file. If this server is an LSP, click Restart CM on the License File Install
Results web page before navigating away from this web page.
on page 8.
At the customer site
a or Step b below:
8 in Before going to
03-300528 Issue 6 May 2009 17