8: Connecting The Ac Power Cord (Mains Lead); Preparing The Receiver; Initializing The Receiver - Sony STR-DN2010 Operating Instructions Manual

8: Connecting the AC
power cord (mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
AC power cord (mains lead)
To the wall outlet

Preparing the Receiver

Initializing the receiver

Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their initial settings.
Be sure to use the buttons on the receiver for
this operation.
?/1
MUSIC
1
Press ?/1 to turn off the
receiver.
2
Hold down MUTING and MUSIC,
then press ?/1 to turn on the
receiver.
3
Release MUTING and MUSIC
after a few seconds.
After "CLEARING" appears on the
display for a while, "CLEARED!"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Note
It takes about 30 seconds for the memory to be
cleared completely. Do not turn the receiver off until
"CLEARED!" appears on the display.
MUTING
continued
GB
39