Table of Contents
Advertisement
3.9
Transport locking devices
Remove transport locks.
Remove beam to support the cantilever.
Remove lock screw on the clamping lever
of the column.
3.10
Cleaning and lubrication
Remove the anti-corrosive agents on the radial drilling machine which had been applied for
transportation and storage. We recommend you use paraffin for this purpose.
Do not use any solvents, thinner or other cleaning agents which could corrode the varnish
on the radial drilling machine. Observe the cleaning agent manufacturer's information and
notes.
Grease all exposed machine parts using an acid-free lubricating oil.
Lubricate the radial drilling machine according to the lubricating plan.
"Maintenance" on page 43
Check if all spindles are running smoothly.
3.10.1 Electrical connection
CAUTION!
Install the connection cable of the machine in such a way that people will not stumble
over it.
Please verify if the type of current, voltage and protection fuse correspond to the values speci-
fied. A protective earth ground wire connection must be available.
min. connection cross section per phase and earthing: 3.5mm
Electrical connection power: 7.853 KVA
Permitted voltage fluctuations under normal operation: ± 10% Volt
Permitted frequency fluctuations: ± 1Hz (50/60 Hz)
Permitted instantaneous shutdown period: 10 ms
Permitted voltage pulse: 200% or less than the actual value of the mains voltage (effective
value): 1.5 ms
Permitted unevenness of a phase: 5% or less
Electrical connection AC ± 10%; 1 Ø; 50/60Hz ±1Hz
Connection cross-section of phase con-
2
ductor [ mm
]
220V
380V
415V
3.5
3.5
3.5
Assembly
Version 1.0
2017-03-13
Clamping lever
Rated current
440V
PE
220V
380V
3.5
3.5
16.2
9.87
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Lock screw
Img.3-5:
Lock screw
2
[ A ]
Connection power [ KVA ]
415V
440V
9.14
8.53
7.853
RD5
GB
Page 33
Advertisement
Table of Contents
