Table of Contents
Advertisement
4.6
Speed adjustment
4.7
Switching on the machine
Switch on the main switch and the operating indicator comes on.
Unlock the EMERGENCY STOP switch.
Firmly clamp the cantilever and drilling head.
Set the stepper switch of the drive motor to L or H.
L - Low speed range.
H - High speed range.
Set the speed on the selector lever
Turn the rotation direction lever to the desired posi-
tion.
Move the spindle sleeve down with the feed lever.
INFORMATION
Move the spindle sleeve down with the feed lever. The spindle starts to turn as soon as it
leaves the upper end position.
The spindle shuts down as soon as it reaches the lower end position.
The spindle only turns if the cantilever has been firmly clamped.
Operation
Version 1.0
2017-03-13
Guide values for speeds:
-1
Speed min
Steel (S235JR)
Ø25 - 40 Ø19 - 25 Ø12 - 19 Ø10 - 12 Ø6 - 10
Steel casting
Ø38 - 55 Ø28 - 38 Ø22 - 28 Ø19 - 22 Ø10 - 19 Ø3 - 10
Tapping
M16-20
useable
automatic
drill feed
ATTENTION!
Only change the speed when stationary. If needed, start the
spindle rotation and stop again to make throwing the gear
lever easier.
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
74
129
236
M6-16
M3-6
3 stages │ 0.05 │ 0.09 │ 0.153
Img.4-3:
Clamping lever of cantilever
381
665
1253
Ø3 - 6
-
-
-
RD5
GB
Page 39
Advertisement
Table of Contents
