Command Authorization Method Configuration Help; Accounting Method Configuration Help - Optical Systems Design OSD2790SFP User Manual

Managed ethernet switch. 24 x 100/1000m sfp and 4 x 1g trunk/uplink sfp
Hide thumbs Also See for OSD2790SFP:
Table of Contents

Advertisement

Methods that involves remote servers are timed out if the remote servers are offline. In this case
the next method is tried. Each method is tried from left to right and continues until a method either
approves or rejects a user. If a remote server is used for primary authentication it is recommended
to configure secondary authentication as 'local'. This will enable the management client to login
via the local user database if none of the configured authentication servers are alive.

COMMAND AUTHORIZATION METHOD CONFIGURATION HELP

The command authorization section allows you to limit the CLI commands available to a
user.
The table has one row for each client type and a number of columns, which are:
Client
The management client for which the configuration below applies.
Method
Method can be set to one of the following values:
No: Command authorization is disabled. User is granted access to CLI commands
according to his privilege level.
Tacacs: Use remote TACACS+ server(s) for command authorization. If all remote
servers are offline, the user is granted access to CLI commands according to his privilege
level.
Cmd Lvl
Authorize all commands with a privilege level higher than or equal to this level.
Valid values are in the range 0 to 15.
Cfg Cmd
Also authorize configuration commands.

ACCOUNTING METHOD CONFIGURATION HELP

The accounting section allows you to configure command and exec (login) accounting.
The table has one row for each client type and a number of columns, which are:
Client
The management client for which the configuration below applies.
Method
Method can be set to one of the following values:
No: Accounting is disabled.
Tacacs: Use remote TACACS+ server(s) for accounting.
Cmd Lvl
Enable accounting of all commands with a privilege level higher than or equal to this level.
Valid values are in the range 0 to 15. Leave the field empty to disable command accounting.
PAGE 59
OPTICAL SYSTEMS DESIGN
OSD2790SFP OPERATOR MANUAL
DOC ID: 10118801

Advertisement

Table of Contents
loading

Table of Contents