Table of Contents
Advertisement
GVRP CONFIGURATION
GVRP CONFIGURATION
Configuration
GVRP
This page allows you to configure the global GVRP configuration settings that are
commonly applied to all GVRP enabled ports.
Enable GVRP globally
The GVRP feature is globally enabled by setting the check mark in the checkbox named Enable
GVRP and pressing the Save button.
GVRP protocol timers
Join-time is a value in the range of 1-20cs, i.e. in units of one hundredth of a second. The default
value is 20cs.
Leave-time is a value in the range of 60-300cs, i.e. in units of one hundredth of a second. The
default is 60cs.
LeaveAll-time is a value in the range of 1000-5000cs, i.e. in units of one hundredth of a second.
The default is 1000cs.
Max number of VLANs
When GVRP is enabled, a maximum number of VLANs supported by GVRP is specified. By
default this number is 20. This number can only be changed when GVRP is turned off.
Buttons
: Click to save changes.
PAGE 217
OPTICAL SYSTEMS DESIGN
Global config
OSD2790SFP OPERATOR MANUAL
DOC ID: 10118801
Advertisement
Table of Contents
