Table of Contents
Advertisement
Access Control List Configuration
Configuration
Security
This page shows the Access Control List (ACL), which is made up of the ACEs defined
on this switch. Each row describes the ACE that is defined. The maximum number of
ACEs is 512 on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for
internal protocol, cannot be edited or deleted, the order sequence cannot be changed and
the priority is highest.
ACE
Indicates the ACE ID.
Ingress Port
Indicates the ingress port of the ACE. Possible values are:
All: The ACE will match all ingress port.
Port: The ACE will match a specific ingress port.
Policy / Bitmask
Indicates the policy number and bitmask of the ACE.
Frame Type
Indicates the frame type of the ACE. Possible values are:
Any: The ACE will match any frame type.
EType: The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE will
not get matched by IP and ARP frames.
ARP: The ACE will match ARP/RARP frames.
IPv4: The ACE will match all IPv4 frames.
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6: The ACE will match all IPv6 standard frames.
Action
Indicates the forwarding action of the ACE.
Permit: Frames matching the ACE may be forwarded and learned.
Deny: Frames matching the ACE are dropped.
Filter: Frames matching the ACE are filtered.
PAGE 97
OPTICAL SYSTEMS DESIGN
Network
OSD2790SFP OPERATOR MANUAL
ACL
Access Control List
DOC ID: 10118801
Advertisement
Table of Contents
