Table of Contents
Advertisement
GLOBAL STORM POLICER CONFIGURATION
Global storm policers for the switch are configured on this page.
There is a unicast storm policer, multicast storm policer, and a broadcast storm policer.
These only affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present in the MAC
Address table. The displayed settings are:
Frame Type
The frame type for which the configuration below applies.
Enable
Enable or disable the global storm policer for the given frame type.
Rate
Controls the rate for the global storm policer. This value is restricted to 1-1024000 when "Unit" is
fps, and 1-1024 when "Unit" is kfps. The rate is internally rounded up to the nearest value
supported by the global storm policer.
Unit
Controls the unit of measure for the global storm policer rate as fps or kfps.
PORT STORM POLICER CONFIGURATION
Port storm policers for all switch ports are configured on this page.
There is a storm policer for unicast frames, broadcast frames and unknown (flooded)
frames. The displayed settings are:
Port
The port number for which the configuration below applies.
Enable
Enable or disable the storm policer for this switch port.
Rate
Controls the rate for the port storm policer. This value is restricted to 10-13128147 when "Unit" is
fps or kbps, and 1-13128 when "Unit" is kfps or Mbps. The rate is internally rounded up to the
nearest value supported by the port storm policer.
Unit
Controls the unit of measure for the port storm policer rate as fps, kfps, kbps or Mbps.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
PAGE 209
OPTICAL SYSTEMS DESIGN
OSD2790SFP OPERATOR MANUAL
DOC ID: 10118801
Advertisement
Table of Contents
