1. Connect the Console Port on UUT to PC with USB cable (Type A to Type B).
2. Using HyperTerminal to set up the following parameters.
Baud Rate: 115200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
•
3. Check the link by pressing <ENTER>. The line should jump to the next line.
4. Using the Username and password to login the switch
Default Username: admin
•
Default Password: (None)
•
7.2
CLI COMMAND FOR IP CONFIGURATION
show ip interface brief: Display the current IP address and subnet mask.
•
configure terminal -> interface vlan 1 -> ip address <IP address> <subnet mask>: Setup the
•
switch IP address.
copy running-config startup- config: Save the current configuration to start-up configuration.
•
PS: All configuration changes must be saved otherwise all the changes will be lost after
rebooting!
PAGE 10
OPTICAL SYSTEMS DESIGN
OSD2512 QUICK START GUIDE
DOC ID: 10116701