Policies Interface Configuration - Optical Systems Design OSD2790SFP User Manual

L2 Priority
L2 Priority is the Layer 2 priority to be used for the specified application type. L2 Priority may
specify one of eight priority levels (0 through 7), as defined by IEEE 802.1D-2004. A value of 0
represents use of the default priority as defined in IEEE 802.1D-2004.
DSCP
DSCP value to be used to provide Diffserv node behaviour for the specified application type as
defined in IETF RFC 2474. DSCP may contain one of 64 code point values (0 through 63). A
value of 0 represents use of the default DSCP value as defined in RFC 2475.
Adding a new policy
Click
Priority and DSCP for the new policy. Click "Save".
The number of policies supported is 32

POLICIES INTERFACE CONFIGURATION

Every interface may advertise a unique set of network policies or different
attributes for the same network policies, based on the authenticated user identity
or interface configuration.
Interface
The interface name to which the configuration applies.
Policy Id
The set of policies that shall apply to a given interface. The set of policies is selected by check
marking the checkboxes that corresponds to the policies.
Buttons
: Click to add new Policy
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
PAGE 162
OPTICAL SYSTEMS DESIGN
to add a new policy. Specify the Application type, Tag, VLAN ID, L2
OSD2790SFP OPERATOR MANUAL
DOC ID: 10118801