Table of Contents
Advertisement
OPTICAL SYSTEMS DESIGN
3.5
CLI OVERVIEW
CONNECT TO CLI
The OSD2790SFP has a Mini USB console port connector located on the front of the unit that is used for
Command Line Interface (CLI) from the PC to the OSD2790SFP via the PC's USB connector.
To operate and control the OSD2790SFP using the CLI, a proprietary driver will be required to be installed
onto the PC being used. The driver can be found and downloaded via the following site:
www.silabs.com
and searching for the CP210x driver. Download the relevant driver for your operating system, install and
follow the installation instructions from your PC.
FIGURE 5: CLI DRIVER DOWNLOAD
DOC ID: 10118801
PAGE 14
OSD2790SFP OPERATOR MANUAL
Advertisement
Table of Contents
