Table of Contents
Advertisement
1. Connect the Console Port on OSD2790SFP (Mini USB) to PC with USB cable.
2. Using HyperTerminal, SecureCRT, etc to set up the following parameters.
•
Baud Rate: 115200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
Flow Control: None
•
3. Check the link by pressing <ENTER>. The line should jump to the next line.
4. Using the Username and password to login the switch
5. If there is no user input for a period of time, the user will be locked out and will require to re-enter
by pressing ENTER.
6. The admin username is operating at the highest priveldge level (level 15) and has full control over
the OSD2790SFP and its configuration. On this level, the admin can reset the OSD2790SFP
configuration to factory default.
PAGE 15
OSD2790SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10118801
Advertisement
Table of Contents
