Mounting Instructions - Siemens Sinamics Connect Series Operating Instructions Manual

Mounting
3.2 Mounting the device
3.2.1

Mounting instructions

Note the following:
● The device is approved for indoor operation only.
● For installation in a cabinet, observe the relevant DIN/VDE requirements or the applicable
country-specific regulations.
● When the device is used in the area of Industrial Control Equipment in accordance with
UL61010-2-201, note that the device is classified as "Open Type". A UL61010-2-201
conform enclosure is therefore a mandatory requirement for approval or operation
according to UL61010-2-201.
● To protect the enclosure of the device against unauthorized opening, after installing the
expansions you can screw the rear panel of the enclosure to the front panel of the
enclosure using two screws. The screws are not included in the scope of delivery. Use
only screws of the type WN1452-K30x20-ST-A2F and tighten the screws using a torque
of 0.5 Nm.
● The device is designed for operation in the second environment (industrial area) and may
not be used in the first environment (residential area) unless the appropriate noise
suppression measures have been adopted.
Fasten securely
NOTICE
Equipment falling due to insufficient load carrying capacity
If the mounting surface for wall mounting does not have a sufficient load-bearing capacity,
the device may fall and be damaged.
• Ensure that the mounting surface on the wall can bear four times the total weight of the
NOTICE
Equipment falling due to incorrect fixing elements
If you use anchors and screws other than those specified below for wall mounting, safe
mounting is not guaranteed. The device can fall and may be damaged.
• Use only the anchors and screws specified in the following table.
Material
Concrete
Plasterboard,
(at least 13 mm thick)
Metal,
(at least 2 mm thick)
26
device, including fixing elements.
Bore diameter
Select according to the specification
of the mounting elements used
Fixing element
Anchor, ∅ 6 mm, 40 mm long
•
Screw, ∅ 4-5 mm, 40 mm long
•
Toggle plug, ∅ 12 mm, 50 mm
•
long
M4 screw × 15
•
M4 nut
•
SINAMICS CONNECT
Operating Instructions, 10/2018, A5E45421408