Siemens Sinamics Connect Series Operating Instructions Manual page 76

Hide thumbs Also See for Sinamics Connect Series:

Table of Contents

Getting connected to MindSphere

6.5 Data mapping

Procedure

1. Click your asset in the asset list, for example, "SINAMICS CONNECT_1".

2. Click the "MindConnect Lib" box.

Note: Once your SINAMICS CONNECT is onboard, the default data source and its data

points are automatically loaded.

The graphic below shows the default data source and data points loaded after the device

is onboard.

Note

Do not click "Enter the edit mode" to edit the default data source or data points by

yourself, otherwise it will cause data mapping failure.

3. Click the "Data mappings" tab.

4. Select the data point you want to map from the list, for example,

"port1_Act_filtered_DC_link_volt", and click "Link variable".

5. Select the asset you created, for example, "SINAMICS CONNECT_1".

Note: To select a different asset, click "Change".

6. Select the aspect, for example, "SC_port1".

SINAMICS CONNECT

Operating Instructions, 10/2018, A5E45421408

Table of Contents