Siemens Sinamics Connect Series Operating Instructions Manual page 37

Hide thumbs Also See for Sinamics Connect Series:

Table of Contents

Requirement

● A flat-bit screwdriver (bit size: 0.4 mm × 2.5 mm).

● Cable with a cross section of 0.2 mm

Note

The signal cable is not provided in the delivery.

Permissible cable and wiring options

Solid conductor

For more information about how to assemble the cable terminals on the SINAMICS

CONNECT side, see Section "Assembly of cable terminals on the device side (Page 91)".

Procedure

The following takes X121 port 1 as an example to indicate the connection of cable on the

SINAMICS CONNECT side.

1. Align the screwdriver with the terminal, and push it downwards on the release lever with a

maximum force of 12 N.

2. Insert the cable from above.

3. Release the screwdriver after the cable is inserted in the indicated position.

Note

Siemens recommends that you use the signal cable with a length less than 3 m.

SINAMICS CONNECT

Operating Instructions, 10/2018, A5E45421408

Stranded conductor

4.2 Connecting the converter to the device

to 1 mm

Stranded conductor, with non-

insulated ferrule

Connecting

Stranded conductor, with insu-

lated ferrule

Table of Contents