Permitted Mounting Orientation And Mounting Types - Siemens Sinamics Connect Series Operating Instructions Manual

Mounting
3.1 Preparing for installation
7. Please keep the enclosed documentation in a safe place. It belongs to the device. You
need the documentation when you commission the device for the first time.
8. Write down the identification data of the device.
3.1.2

Permitted mounting orientation and mounting types

The device can be attached horizontally or vertically on a DIN rail or to a wall.
Horizontal mounting, preferred
Take into account the permitted temperature range for operation that depends on the
mounting position in accordance with Section "Ambient conditions (Page 86)".
24
NOTICE
Damage from condensation
If the device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, for example in cold weather, moisture could build up on or inside
the HMI device (condensation). Moisture causes a short circuit in electrical circuits and
damages the device.
• Store the device in a dry place.
• Bring the device to room temperature before starting it up.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait approximately 12 hours or until the device is
completely dry before switching it on.
Vertical mounting
Operating Instructions, 10/2018, A5E45421408
SINAMICS CONNECT