Mounting/Extending; Installing The Device - Siemens SIMATIC PN/J1939 LINK Operating Instructions Manual

Mounting/Extending

6.1

Installing the device

PN/J1939 LINK can be mounted on a 35 mm standard mounting rail according to
DIN EN 60715 or on a control panel.
Information on the selection of the location of use as well as reliable mounting positions and
minimum clearances is available in the section Installation location (Page 28).
Mounting on a standard mounting rail
Proceed as follows:
1. Hook the PN/J1939 LINK onto the mounting rail.
2. Swivel the PN/J1939 LINK backwards until it engages audibly.
Figure 6-1
NOTICE
If the device is not installed on a control panel, the mounting sliders (see figure Control
panel mounting item
Otherwise the mounting sliders may warp if they are exposed to hot and humid ambient
conditions for a long time.
SIMATIC PN/J1939 LINK
Operating Instructions, 12/2018, A5E45307564-AA
PN/J1939 LINK standard rail mounting
①
) must always be in the default positions set at the factory.
6
33