Siemens Sinamics Connect Series Operating Instructions Manual page 77

Hide thumbs Also See for Sinamics Connect Series:

Table of Contents

7. Select the variable you want to map to the data point, for example,

"port1_Act_filtered_DC_link".

8. Click "Accept", and the data point is mapped.

The graphic below shows the new data mapping added.

Note

Only units and data types that match exactly with the aspects and variables are available.

If the units or the data types are not matched, the variable cannot be connected to the

data point (also case sensitive).

9. Repeat steps 4 to 8 until all of your data points are mapped.

Note

You cannot map the data point named "Others". It is an automatically generated data

point for time series uploading protection buffer.

Result

The data points are now mapped to the variables.

SINAMICS CONNECT

Operating Instructions, 10/2018, A5E45421408

Getting connected to MindSphere

6.5 Data mapping

Table of Contents