Broadcast Test Results Read; Broadcast Test Data Send - Omron SYSMAC LINK C1000H-SLK21-V1 System Manual

CV-mode Commands for SYSMAC LINK Units

6-6-9 BROADCAST TEST RESULTS READ

Command Block
Response Block
Parameters

6-6-10 BROADCAST TEST DATA SEND

Command Block
110
response differs from that transmitted in the command, an error occurred in the
internode echo test.
Reads the results (number of receptions for each node) of the broadcast tests
carried out using the BROADCAST TEST DATA SEND command. Refer to
6-6-10 BROADCAST TEST DATA SEND for details on that command.
08 02
Command
code
08 02
Command Response
code code
Number of receptions (response): The number of times that the BROAD-
CAST TEST DATA SEND command has been executed since the last BROAD-
CAST TEST RESULTS READ command was executed.
When this command is executed, the number of receptions data stored in the
destination nodes is cleared. If the number of receptions does not equal the
number of times that the BROADCAST TEST DATA SEND command has been
executed since the last BROADCAST TEST RESULTS READ command was
executed, an error has occurred.
Sends the test data in the command to all nodes in the specified network. No
response will be returned when this command is executed, but reception of the
test data can be verified by executing the BROADCAST TEST RESULTS READ
command. Refer to 6-6-9 BROADCAST TEST RESULTS READ for details.
512 bytes max.
08 03
Command Test data
code
Note Make the following control data settings when executing this command:
a) Destination node number:
b) Destination node unit number:
c) Response Flag (bit 13 of C+1): ON (response not returned)
Number of
receptions
FF (broadcast transmission)
FE (to SYSMAC LINK Units)
Section 6-6