Optical Fiber Cable - Omron SYSMAC LINK C1000H-SLK21-V1 System Manual

Cable Connection

3-4-2 Optical Fiber Cable

Required Components
1, 2, 3...
28
5. Any bends in the coaxial cable must be 45 mm in radius or greater (six times
the outer diameter of the cable). When laying the cable, make wider bends
of 110 mm in radius or greater (15 times the outer diameter of the cable).
Radius
> 45 mm
Note 1. Check to be sure that the coaxial cable if firmly locked into place after con-
necting it.
2. Do not pull on the cable. Pulling on the cable could break wires inside.
3. Do not bend the cable past the minimum radius. Bending the cable too far
could break wires inside.
4. Do not place heavy objects on the cable or connectors. Heavy objects could
break wires inside.
1. Optical fiber cable:
Use Hard Plastic-clad Optical Fiber Cable (H-PCF). Refer to Appendix A
Standard Models for details on available lengths and colors.
2. Optical Connectors:
There are two types of Optical Connector available, as shown below. Use
the cable splicing connector to splice cable.
Function
Node-cable connection
Cable splicing
Note Using an inline adapter to splice the cable will reduce the maximum
transmission distance because of loss at the junction. Refer to your
hard plastic-clad optical fiber cable (H-PCF) installation manual for
details.
3. Optical Connector Assembly Tools:
These tools are required to attach the Optical Fiber Cable to the Optical
Connector.
Optical Connector Assembly Tool Set
S3200-CAK1062
Note Optical fiber cable cutters are included.
4. Optical Fiber Tester (Optical Power Tester):
Tester Set
S3200-CAT2700
Model number
S3200-COCF2071
S3200-COIAT2000
(inline adapter)
S3200-COCF2071 (C1000H)
S3200-COCF2571 (C200HS)
Head Unit
S3200-CAT2702 S3200-COCF2071 (C1000H)
S3200-COCF2571 (C200HS)
Section 3-4
Number required
2 for each node
1 for each break in the cable
Applicable Connectors
Applicable Connectors