File Memory Block Write - Omron SYSMAC LINK C1000H-SLK21-V1 System Manual

CV-mode Commands for PCs

6-5-16 FILE MEMORY BLOCK WRITE

Command Block
Response Block
Parameters
100
Kind of data
Bits 0 to 2 indicate the kind of data, as shown in the following table.
Bit status
2 1 0
0 0 0 None
0 0 1 I/O data
0 1 0 Program
0 1 1 Comments
No. of comments (response): If the block contains comments data, this byte
indicates the number of comments.
Block data (response): The 256 bytes of data from the indicated block.
Writes the 256 bytes of data in the command to the indicated block of file
memory. This command can be used with the C1000H and C2000H only.
22 11
Command Block no.
Kind of
code
data
No. of
comments
22 11
Command Response
code code
Kind of data (command): Indicate the kind of data in the block, as follows:
Bit
7 6 5 4 3
0 0 0
Kind of data
Bits 0 to 2 indicate the kind of data, as shown in the following table.
Bit status
2 1 0
0 0 1 I/O data
0 1 0 Program
0 1 1 Comments
Note *Turn bit 7 ON when the block contains the END(01) instruction or the
block is the last.
Kind of data
256 bytes
Data
2 1 0
Kind of data (see table below)
1: Protected
1: Block contains END(01)
(program only)*
Kind of data
Section 6-5